Attaching The Front Handle - Oregon ST275 GSL Manual De Instrucciones

ATTACHING THE FRONT HANDLE

The front handle fits on the shaft at a
comfortable distance between the rear handle
and the trimmer motor housing (Fig 4)
• Grip the front handle near the clamping
point (1)
• Snap the front handle onto the shaft so that
the clamp is nearest the rear handle (2)
• Insert the front handle adjustment knob
through the hole on the front handle (3) and
tighten
FIG. 4
Trimmer/Edger Model ST275-GSL
Unpacking and Assembly
(1)
(3)
(2)
ATTACHING THE GUARD
The guard fits onto the slot on the trimmer
motor housing (Fig 5)
• Turn the trimmer/edger upside down
• Slide the guard onto the trimmer until it snaps
into place (1)
• Tighten the screws on the housing (2) until
fully seated to hold the guard in place
• Make sure that the line cutting blade (3)
is attached to the guard to insure that the
trimmer/edger functions correctly
IMPORTANT: Install the screws to make
sure the guard stays in place.
FIG. 5
(2)
(3)
(1)
15