Removing And Replacing The Gator® Speedload™ (Gsl) Head - Oregon ST275 GSL Manual De Instrucciones

Removing and Replacing the
Gator® Speedload™ (GSL) Head
If the GSL head is cracked or broken, it should
be removed and replaced If there is a build-up
of clippings or debris between the head and the
guard, it is easier to clean the trimmer/edger if
the head is removed first
• Remove the battery, then place the trimmer/
edger upside down
• Follow the instructions in "Opening The GSL
Head "
• Use a straight-blade screwdriver to restrain
the spindle and rotate the trimmer base
counter-clockwise to loosen the center nut
(Fig 25)
FIG. 25
• Pull out the GSL base
• Remove the grass wrap protector from the
trimmer head (Fig 26)
FIG. 26
24
Maintenance and Cleaning
• Insert the new grass wrap protector
• To attach a new GSL head, slide the nut into
the center opening of the GSL head (Fig 27)
FIG. 27
• Place the GSL head inside the trimmer
housing
• Tighten the nut securely (Fig 28)
FIG. 28
• Follow the instructions in "Loading a New GSL
Disk" to place a new disk of trimmer line into
the trimmer/edger
• Close the head
Trimmer/Edger Model ST275-GSL