Opening The Gator® Speedload™ (Gsl); Closing The Gsl Head - Oregon ST275 GSL Manual De Instrucciones

Opening the Gator® Speedload™
(GSL)
WARNING: A battery operated tool
with the battery pack inserted is always
on and can start accidentally. Remove
the battery pack from the trimmer/edger
before inspecting, cleaning, or performing
maintenance.
If you detect a problem with the operation of
the GSL Cutting System and need to inspect
the disk or head, follow these steps to open the
GSL head:
• Remove the battery, then place the trimmer/
edger upside down
• Press the GSL head to release the bottom
part of the base (Fig 19)
FIG. 19
22
Maintenance and Cleaning

Closing the GSL Head

• Check the disk and clear any blockage or
replace the disk See "Replacing the Gator®
SpeedLoad™ (GSL)"
• Remove clippings, dirt, and debris
• Place GSL head back onto the base and press
firmly until it clicks into place (Fig 20)
FIG. 20
Trimmer/Edger Model ST275-GSL