Promax PROLINK-4C Manual De Instrucciones página 191

USER'S MANUAL. PROLINK-4C
Figure 35.- Calibrate function selection for Sat IF Test.
2.- MEASUREMENT OF THREE PILOTS THROUGHOUT THE NETWORK
Once PROLINK-4 has been calibrated, connect the RP-050 to the point where
it will be connected the satellite dish (signal source) and start to take level
measurements in the different distribution outlets using the PROLINK-4C. On the
screen will appear the attenuation values for the three pilot frequencies measured in the
outlet plug (see the following figure).
02/2003
10
FU N C IO N ES
0
-10
-20
- - MHz - - MHz
REF. - - dBuV - - dBuV
PLUG
- - dBuV - - dBuV
ATT.
Figure 34.- Sat IF test.
FU N C TIO N S
C A L IB R AT E
E N D T E S T
B AT T E R Y & L N B
D I S E q C
N E X T
- - MHz
- - dBuV
- - dBuV
1/2
Page 71