Replacing The Battery; Important Notice - Promax PROLINK-4C Manual De Instrucciones

6.3

Replacing the Battery

Battery must be replaced whenever the capacity of the fully-charged battery is
noticeably diminished. To change the battery, follow next procedure:
Remove the rear holster, if in place.
-
The battery compartment is located in the rear panel of the instrument. Remove
-
the securing screw (A) and washer from the compartment cover as shown in
the previous figure (it shows the battery compartment once the cover and
connector linking the battery to the board have been removed).
Disconnect the battery connector strip from the board, and replace the battery
-
with a new one of the same characteristics.
The configuration data and all data stored in the memories will be lost when the battery
is disconnected.
Place and connect the battery to the board using the connector.
-
WARNING
Avoid any type of short circuit among the cables connected to the battery,
since the resulting high current may cause serious damage to the
instrument.
Insert the battery compartment cover in the rear panel of the PROLINK-4C and
-
lock in place with the securing washer and screw (A).
If you wish, replace the holster.
-
Page 100
Figure 54.- Battery compartment.
USER'S MANUAL. PROLINK-4C

IMPORTANT NOTICE

02/2003