Taking Your Blood Pressure Reading - HealthSmart Premium Serie Manual De Instrucciones

TAKING YOUR BLOOD PRESSURE READING

Proceed only after reading the previous sections of this manual.
1. First, select the correct User bank, by pressing the SET
button. The User symbol will begin to blink. Then press the
MEMORY button to switch between User 1 & 2. Once the
desired User is selected, press and hold the POWER button
until the unit powers OFF.
2. Rest your elbow on a solid surface with your palm facing
upward. Elevate your hand so that the cuff is at the same
level as your heart, Fig. 1. Relax your left hand. Sit comfortably
and don't cross your legs. The middle of the cuff should be at
the level of the right atrium of the heart.
3. Press the POWER button again to turn the unit ON and begin
the measurement.
4. This unit will first run a self-test, Fig. 2.
5. If the Heart Spot Technology feature is ON, the display will
blink "00" until the monitor is at the same level as your heart,
Fig 3. Raise or lower your arm until the "00" stops blinking.
6. Once the monitor is in the correct position, the "00" will
stop blinking and "P" will appear on screen, Fig 3. Hold your
wrist at this position during the entire measurement. If there
is any residual air in the cuff, the monitor will flash " " until
pressure is stabilized as shown in Fig. 4.
Measurement value
becomes lower.
Correct measurement position
(at same height as heart).
Measurement value
becomes higher.
Fig. 1
mmHg kPa
AVG
( )
( )
/
17
No
AVG
( )
( )
/
/
/
mmHg
/
mmHg kPa
No
Fig. 2
Fig. 3
Fig. 4
/