Cleaning The Thermal Head - Epson TM-T58 Manual Del Usuario

5. Cut off the excess paper.
Setting the Memory Switch
With Memory switch, you can set the following:
❏ Selecting the transmission speed (serial interface only): 9600bps
(default)/19200bps
❏ Selecting darkness/lightness of the print results (only available at
the print speed of 70 mm/s): 100% (default)/110%
❏ Selecting print speed: 100 mm/s (default)/70 mm/s
To set the memory switch, follow the steps below.
1. Open the printer cover and turn ON the printer while pressing the
FEED button.
2. Press the FEED button twice and close the printer cover.
3. Setting items and operation method will be printed. To set the
memory switch, follow the instruction.
4. When the initial setting is complete, the settings are saved and the
printer is initialized.
5. The printer is ready to print once the initialization is complete.
Note:
The print speed of raster bit image and barcode cannot be set to 100mm/s.

Cleaning the Thermal Head

To ensure print quality of receipts, periodical maintenance on the
thermal head is recommended (once every 3 months).
After printing, the thermal head can be very hot. Be careful not to
touch it and to let it cool before you clean it. Do not damage the
thermal head by touching it with your fingers or any hard object.
CAUTION:
TM-T58 User's Manual 7
English