Checking And Cleaning The Print Head; Maintaining The Printer - Epson SureColor S Serie Guía De Referencia Rápida

Checking and Cleaning the Print Head

If your prints show a color shift or horizontal lines, check the print head nozzles for clogs or deflections. If
necessary, run a cleaning cycle.
Note: You can set the printer to automatically check the nozzles periodically using Auto Nozzle Check or before
each print job using Print Nozzle Pattern. You can also run different head cleaning levels and set up automatic
cleaning cycles.
Press the Maintenance button.
#
1.
Select
Nozzle Check
2.
Examine the printed pattern to determine if the print head needs cleaning.
3.
If you need to clean the print head, select one of the following:
4.
(if all numbered patterns have faint or missing segments)
• All Nozzles
• Selected Nozzles
Choose the nozzle arrays (corresponding to the numbered patterns) to be cleaned.
5.
Select and press
Proceed
6.
Select a cleaning level and press
7.
Print a nozzle pattern and check the results to determine whether the head cleaning was successful.
8.
If you cannot recover all nozzles by running the heaviest cleaning cycle, you need to wash the ink system,
as described on page 27.

Maintaining the Printer

You should regularly check the ink status and replace cartridges (see page 25) as necessary. For the
S50670/S70670, the printer performs automatic maintenance to prevent ink accumulating and causing
clogs. Do not turn the printer off, or this maintenance will not be performed.
and press .
OK
Cleaning not needed
(if only some of the numbered patterns have faint or missing segments)
.
OK
.
OK
Checking and Cleaning the Print Head
Clean the print head
|
23