Technical Specifications; Troubleshooting - Viking GE 105 Manual De Instrucciones

18. Technical specifications

GE 105.1
Power 2200 W
Amperage rating 9.8 A
Rated voltage 230 V
Frequency 50 Hz
Speed 2800 rpm
Fuses 16 A*
Protection class I
Type of protection Splash proof (IP
X4)
Operating conditions P40
40 s load time
60 s idle time
Tightening torque 25 Nm
Screw
Blade disc
Tightening torque 10 Nm
Screw
Reversible blade
L/W/H 77/48/97 cm
Weight 19 kg
19 kg (CH)
20 kg (GB)
0478 201 9910 E - EN
Sound emissions:
In accordance with Directive 2000/14/EC:
Guaranteed sound
power level L 104 dB(A)
WAd
In accordance with Directive 2006/42/EC:
Sound pressure level
at workplace L 93 dB(A)
pA
Uncertainty K 3 dB(A)
pA
* Caution!
In the case of mains fuses of less than
16 A, these may be tripped during start-
up or in the case of high load operation
of the machine.

19. Troubleshooting

If necessary, contact a specialist
dealer; VIKING recommends VIKING
specialist dealers.
Fault:
Motor does not start
Possible cause:
– Motor overload protection activated
– No mains voltage
– Electric cable, plug, plug connector or
switch defective
– Fuse in UK plug damaged (only applies
to machines for UK)
– Feed chute not properly closed - safety
cut-off switch actuated (safety interlock)
– Blade disc blocked
– Locking device is not reset
Remedy:
– Allow machine to cool down (
– Check power cable and fuse
( 10.1)
– Check cable, plug, connector and
switch and replace if necessary (by
electrician) ( 10.1)
– Replace fuse
– Close feed chute properly and tighten
screws ( 11.3)
– Remove feed chute and remove
shredder deposits from the housing
(Important: disconnect the power cable)
( 11.2)
– Reset locking device (
Fault:
Frequently tripped mains fuse
Possible cause:
– Unsuitable electric cable
– Power overload
– Machine overloaded
Remedy:
– Use suitable electric cable (
– Connect the machine to another circuit
– Reduce quantity of shredding material;
reverse, re-sharpen or replace the
shredding blades
Fault:
Reduced shredding performance
Possible cause:
– Blunt blades
Remedy:
– Reverse, re-sharpen or replace
shredding blades
8.6)
11.4)
10.1)
( 11.5)
( 11.5)
39