Operation Without Dmx Controller; Selecting The Operating Mode - IMG STAGELINE LED-500DX/WS Manual De Instrucciones

(18). Once the DMX controller is switched off,
GB
all LEDs will go out.
To memorize, press the button ENTER (11).
Display on or off
Use the button
The display (6) will always be on.
The display will be switched off approx. 60 s
after pressing the last button. It will be switched
on again the next time a button is pressed.
To memorize, press the button ENTER (11).
Display representation
Use the button ENTER (11) to select and memorize at
the same time:
normal representation
representation turned by 180°
Approx. 10 s after pressing the last button, the adjust-
ing menu will be exited automatically.

6 Operation without DMX Controller

When there is no DMX control signal at the jack DMX
INPUT (18), the yellow LED MASTER (8) will light up,
the display (6) will show the mode adjusted (
or ) and the unit will automatically operate
according to the mode adjusted. For this purpose, the
MASTER mode must be adjusted and the Blackout
mode must be deactivated,

6.1 Selecting the operating mode

When selecting the operating mode, make sure that
the next button (9 – 11) is pressed within 10 seconds,
otherwise the adjusting process will end and the unit
will return to the previous mode. The menu structure
can be found on page 15.
6.1.1 Music-controlled stroboscope
Adjust the MASTER mode (
will be displayed. In addition, the music control
must be activated:
1) Press the button MENU (9) so many times until
will be shown in the display (6).
2) Activate the menu item
ENTER (11). The display will show the operating
state:
= music control switched on
= music control switched off
The LEDs will flash regularly.
3) Switch on or off the music control with the button
or (10) and confirm with the button ENTER. The
display will go back to the indication of the mode
( ) and after 10 seconds the unit will start the
operation in the selected mode.
12
or (10) to select:
chapter 5.1.
chapter 5.1) so that
with the button
Adjust the SENSITIVITY control (14) for the micro-
phone in such a way that the dynamic power of the
music will be optimally reproduced by the stroboscope.
The green LED SOUND (12) will shortly light up with
each control signal created by the sound picked up
with the microphone (15).
Notes
1. When the volume at the music system is modified, the
microphone sensitivity must be adapted accordingly with
the rotary control.
2. When the volume is too low, in music breaks, or when
the SENSITIVITY control is set to the left stop, the LEDs
will flash regularly.
6.1.2 Manual adjustment of dimmer
and stroboscope
The LEDs of the stroboscope may permanently light
up with an adjustable brightness or flash with the
adjusted brightness. The flash frequency can also be
adjusted. The MASTER mode must be adjusted so
that is shown in the display (
1) Press the button MENU (9) so many times until
(Show Mode) will be displayed. Activate the
menu item with the button ENTER (11). The display
will show .
2) Switch to with the button
firm with the button ENTER. The display now shows
,
.
3) Press the button ENTER again. The display will
show the brightness value adjusted.
4) Adjust the brightness with the button
tion 0 – 255) and confirm with the button ENTER.
The display will go back to the indication of the
mode ( ) and the LEDs of the stroboscope will
be switched off. For not activating the stroboscope
function, continue with operating step 8.
5) For activating the stroboscope function with the
adjusted brightness, after pressing the button
ENTER, switch with the button
tion (stroboscope) within 10 seconds.
6) Press the button ENTER again. The flash fre-
quency value adjusted will be displayed.
7) Use the button
(indication 0 – 255) and press the button ENTER to
confirm. The display will return to the indication of
the mode (
will be switched off.
8) 10 seconds after pressing the button ENTER the
unit will start the operation in the adjusted mode. To
switch back to the music-controlled stroboscope
mode, press the button MENU. The display will go
to the indication
operation will start.
Note: After switching off and on again, the music-controlled
stroboscope mode will always be activated.
chapter 5.1).
or (10) and con-
or
or to the indica-
or to adjust the flash frequency
) and the LEDs of the stroboscope
and after a few seconds the
(indica-