Reception Of The Machine; Unpacking - OEM HENERGO HV/45 E-1 Manual De Uso Y Mantenimiento

G45
Technical data - Transport and unpacking

2.3 - RECEPTION OF THE MACHINE

Upon reception of the machine make sure that the packing
is complete and not damaged. Should the packing be
complete, remove it as specify at point 2.4 (aside from
different manufacturer's instructions).
Check if the instruction booklet is inside the packing
as well as the components speci ed in the transport
documentation.
In case any damage or defect is found:
a- Inform immediately the transport company and your
agent, both by phone and by registered letter with
return receipt;
b- Manufacturer shall also be informed.
2.4 - UNPACKING (Fig. 3)
To remove the packing from the machine proceed as
follows:
• Cut the straps (1) that tie up the carton.
• Open the carton (2), by removing the metallic clips.
• Remove the cardboard packaging (2).
• Check if everything is complete.
•
Open the door (3) of the oven, remove loose com-
ponents.
• Check if the delivery is complying with the PACKING
LIST.
DANGER
The packing elements ( plastic bags, carton, nails,
etc...) shall be kept away from the reach of the chil-
dren, since they are potential danger sources, so,
they shall be gathered and sent to special centres
to correctly be recycled.
Any damage or defect or non conformity with the
packing list should be immediately reported and, in
any case, it should be noti ed within 8 days from the
date of reception of the machine. On the contrary the
goods are to be considered as accepted.
IMPORTANT
FIG. 3
2
1
1
3
EN - 9