LAVAZZA A Modo Mio DESEA Instrucciones De Uso página 61

PREPARING THE MILK-BASED BEVERAGES
If you wish more foam in the beverage, you can increase
the amount of the same by pressing the FOAM control
button .
The machine will emit an acoustic signal when the button
is pressed.
If you wish to go back to the normal foam amount, press
the FOAM control button again
The machine will emit an acoustic signal when the button
is pressed.
The foam amount cannot be changed when the
beverage is being supplied.
.
61
Press the CAPPUCCINO
the machine. After a few seconds the machine will start
to warm and froth the milk. When ready, the machine
delivers the measure of coffee in the jug and stops au-
tomatically.
Do not use the milk frothing jug to conserve
the beverages. Always clean the jug thoroughly
after each use.
The supply button will light up to a blinking white light
when the product is being supplied. You can stop supply-
ing by pressing the supply button again.
Do not make more than 5 consecutive beverages.
The machine will be ready to use again after about 10
minutes.
E N
(80 cc) button to start