Operating Elements And Connections; Safety Notes - IMG STAGELINE LED-620W Manual De Instrucciones

All operating elements and connections de -
GB
scribed can be found on page 2.
1 Operating Elements
and Connections
1 Mounting bracket
2 Locking screws for the mounting bracket (1)
3 Cooling fins for the LEDs
4 Support for the mains fuse;
only replace a blown fuse by one of the same
type
5 Mains jack for connection to a socket (230 V~ /
50 Hz) via the supplied mains cable
6 Ring screw for fixing a safety rope
7 Microphone for music-controlled light change
8 Mains output jack for connection of another light
effect unit

2 Safety Notes

The unit corresponds to all relevant directives of
the EU and is therefore marked with
WARNING The unit is supplied with hazardous
mains voltage. Leave servicing to
skilled personnel only. Inexpert han-
dling or modification of the unit may
cause an electric shock hazard.
It is essential to observe the following items:
G
The unit is suitable for indoor use only. Protect it
against dripping water and splash water, high air
humidity and heat (admissible ambient tempera-
ture range 0 – 40 °C).
G
Do not place any vessels filled with liquid, e. g. a
drinking glass, on the unit.
G
Do not set the unit into operation, or immediately
disconnect the mains plug from the mains socket
if
1. there is visible damage to the unit or to the
mains cable,
2. a defect might have occurred after a drop or
similar accident,
3. malfunctions occur.
The unit must in any case be repaired by skilled
personnel.
G
Never pull the mains cable to disconnect the
mains plug from the mains socket, always seize
the plug.
G
No guarantee claims for the unit and no liability
for any resulting personal damage or material
damage will be accepted if the unit is used for
other purposes than originally intended, if it is not
6
safely mounted, not correctly connected or oper-
ated, or not repaired in an expert way.
G
Important for U. K. Customers!
The wires in this mains lead are coloured in
accordance with the following code:
green/yellow = earth
blue = neutral
brown = live
As the colours of the wires in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
1. The wire which is coloured green and yellow
must be connected to the terminal in the plug
which is marked with the letter E or by the earth
symbol , or coloured green or green and yel-
low.
2. The wire which is coloured blue must be con-
nected to the terminal which is marked with the
letter N or coloured black.
3. The wire which is coloured brown must be con-
nected to the terminal which is marked with the
letter L or coloured red.
Warning – This appliance must be earthed.
.
3 Applications
This unit serves for effect illumination, e. g. on
stage, in discotheques or festival rooms. It creates
white and coloured light beams which are deflected
via two mirror wheels and two mirror drums. The
movements of the mirrors and switching on and off
of the light are music-controlled via the integrated
microphone. Two extra bright LEDs are used as a
light source. Compared to incandescent lamps or
gas discharge lamps, they have a low power con-
sumption, a low heat development and a long life.
4 Mounting
G
Always place the unit so that a sufficient air cir-
culation is ensured during operation. The cooling
fins (3) for the LEDs must not be covered.
G
The distance to the radiated area should be
50 cm as a minimum.
Fix the light effect unit via its mounting bracket (1)
to a suitable place, e. g. with a stable mounting
screw or a support for lighting units (C hook) to a
cross bar. To align the unit, release the two locking
If the unit is to be put out of operation
definitively, take it to a local recycling plant
for a disposal which is not harmful to the
environment.