Clutch Adjustment - Ingersoll Rand 41 Series Manual Del Usuario

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this
tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable
positions may be harmful to
your hands and arms. Stop
using any tool if discomfort,
tingling feeling or pain occurs.
Seek medical advice before re-
suming use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.

CLUTCH ADJUSTMENT

External
1. Rotate Sleeve until opening in Housing is visible.
2. Depress bit to engage clutch, then rotate until notch in
Adjustment Washer or is visible.
3. Insert No. 1 Phillips screwdriver in notch to turn gear
teeth on Nut.
4. Turning clockwise will decrease torque.
5. Turning counterclockwise will increase torque.
WARNING LABEL IDENTIFICATION
Always wear hearing
protection when operating
this tool.
Do not carry the tool by
the hose.
90 psig
Operate at 90 psig (6.2 bar/
(6.2bar/620kPa)
620 kPa) Maximum air pressure.
ADJUSTMENTS
WARNING
WARNING
WARNING
Internal
1. Remove Clutch Housing, Bit Holder and Clutch
Assembly from tool.
Clutch housing has left–hand threads.
2. With bit in Bit Holder, clamp bit in vise.
3. Place Clutch Assembly on Bit Holder.
4. Engage jaws, hold Clutch Assembly from turning.
Then rotate Adjustment Nut with 7/8" wrench.
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before instal-
ling, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.