Ingersoll Rand 41 Series Manual Del Usuario página 29

The Clutch Housing (126) has left–hand threads.
14. Assemble Clutch Housing (91) onto tool.
15. Refer to section on Clutch Adjustment.
Positive Jaw
1. Assemble Jaw (111) to gearing spindle and secure
with Retaining Ring (112).
2. Coat Pin Assembly (113) with the recommended Oil
and slide Spring (87) over Pin Assembly.
3. Install Pin Assembly and Spring (87) into spindle. Use
the recommended lubricant to lubricate spindle, jaw
face and Ball (48) of Bit Holder (89) and assemble to
tool.
The Clutch Housing (126) has left–hand thread.
4. Assemble Clutch Housing onto tool.
5. Refer to section on Clutch Adjustment.
Auto Shut–Off
1. Lubricate ball grooves of Clutch Spindle (103) with
the recommended lubricant.
2. Install eleven Balls (105) into groove.
3. Slide spindle into Bit Holder, securing Balls.
4. Assemble twelve Balls (105) into Bit Holder. Then
with Retaining Ring (108).
5. Use the recommended lubricant to lubricate ball
pockets of Bit Holder and install six Balls (106) into
pockets, securing with Thrust Race (101).
MAINTENANCE SECTION
SAVE THESE INSTRUCTIONS. DO NOT DESTROY.
6. Use the recommended lubricant to lubricate Thrust
Bearing (78). Assemble Thrust Bearing and Thrust
Race (100) to spindle.
7. Coat Plunger (102) with the recommended lubricant
and assemble to spindle, securing with Balls (104).
Assemble two Balls per hole.
8. Secure Balls with Ball Sleeve (99).
9. Assemble Spring (98) and Guide (97) to spindle,
securing with Retaining Rings (96).
10. Install Clutch Spring (95).
11. Lubricate face of Adjustment Washer (94) with the
recommended lubricant and install on spindle.Thread
Adjustment Nut (72) onto spindle, securing with Snap
Ring (71).
12. Lubricate Ball (48) of Bit Holder with the
recommended lubricant.
13. Assemble Springs (109) and (110) into spindle.
Assemble Spring (109) with large diameter into
spindle first.
14. Assemble clutch assembly to tool.
The Clutch Housing (91) has left–hand threads.
15. Assemble Clutch Housing to tool.
16. Refer to section on Clutch Adjustment.
29