Current Clamp (Optional) - Abicor Binzel FEC W3 Manual De Instrucciones

6 Putting into operation

6.3 Current clamp (optional)

If welding conditions are not favourable, a current clamp instead of an earth cable may be used. This is connected to the
FEC W3 via the 4-pole plug and routed above the earth cable and cable assembly as required. When the welding process
starts, the FEC W3 receives a signal and starts the extraction process.
4
3
1 A/Auto button
Fig. 7 Current clamp
1 Connect the current clamp plug to the current clamp socket (4).
2 Route the current clamp above the earth cable or the cable assembly.
1 Current clamp
Fig. 8 Current clamp above cable assembly
NOTICE
• It is imperative that you ensure that the red dot on the current clamp is always pointing in the direction of the current
flow.
3 Press the A/Auto (1) button on the control panel.
The extraction process starts as soon as you start the welding process.
EN - 16
1
2
2 Motor protective switch
1 2
3
2 Red dot
3 Power cable connector 4
3 Cable assembly
FEC W3
Socket for current clamp (optional)
BAL.0675.0 • 2019-09-16