Silk’n Jewel Manual Del Usuario página 21

Repeat this test for each part of the body you wish to treat.
You are now ready to use your Silk'n Jewel.
Before treating an area, the skin should be shaved, clean, dry
and free of any powders, antiperspirants or deodorants. Do not
wax, pluck or tweeze the hair out.
1. Be sure to cover up moles, warts or other marks on the
skin that should not be treated.
2. Press the control button. The device will turn on, the level
1 energy indicator light will be on, and a fan sound will
start.
3. Approximately 1 second after pressing the control button,
the ready light will turn on. The device is then ready to use
at the lowest energy level.
4. Set the energy level. Press the control button repeatedly
to increase the energy level until you have the level you
want. The energy level indicator lights indicate the
energy level setting (refer to section 7.2 Energy levels).
5. Decide if you wish to treat the area by Gliding or Pulsing
(refer to section 7.3 Pulsing and gliding).
6. Apply the treatment surface to the skin. Make sure that the
skin is spread evenly and smoothly. When the treatment
surface is in full contact with the skin, the ready light will
start blinking slowly.
7. The device will first determine the colour of your skin
automatically and it will flash a pulse of light onto your skin.
You will feel a mild sensation of warmth and tingling, and
you may hear a popping sound.
19
EN