After Treatment; Maintenance - Silk’n Jewel Manual Del Usuario

8. If you are pulsing, remove the device from your skin. The
device will immediately recharge for the next pulse. After
a few seconds (depending on the energy level) the ready
light will turn on again, and start blinking slowly when
EN
pressed against the skin.
9. If you are pulsing, repeat the process. If you are gliding,
simply continue. Continue to pulse or glide until you have
treated the area fully.
C
Stop use immediately, if your skin blisters or burns.

9. After treatment

When you have finished your treatment session:
1. Turn the device off by giving the control button an
extended press. Remember the last energy level setting
you used, because it will not be restored when you turn
the device on again.
2. Remove the adapter from the electrical outlet.

10. Maintenance

It is important to clean your Silk'n Jewel device after each
treatment.
U
Unplug the device.
U
To clean the device including the treatment surface,
wipe with a clean, dry cloth. Never use acetone or other
abrasive fluids, because they will damage your device.
U
After cleaning, we recommend you store the device in its
original box.
C
Never immerse your Silk'n Jewel or any of its parts in water.
20