Getting Started; Connecting The Adapter; Turning The Power On And Off; Adjusting The Volume - Roland C-190 Manual Del Usuario

2.

Getting started

Connecting the adapter

Note: To prevent malfunction and/or damage to the speakers or
other devices, always turn down the volume and switch off all
devices before making any connections.
(1) Connect the supplied PSB-4U adapter to the DC IN
socket on the rear panel of the C-190.
DC IN 12V
USE ROLAND PSB-4U
ADAPTOR ONLY
(2) Connect the other end to an AC outlet.

Turning the power on and off

Your C-190 is fitted with an amplifier and speakers so
that you do not need additional devices.
(1) Turn the volume all the way down.
VOLUME
(2) Press the [POWER¥SWITCH] button on the rear
panel to turn on the power.
Press at least one tilt tab, because all sounds will be
off immediately after switching on the C-190. Adjust
the volume to your liking.
Note: Your C-190 is equipped with a protection circuit. A brief
interval after power up is required before it will operate nor-
mally.
Turning off the power
(1) Set the [VOLUME] slider to the minimum position.
(2) Press the [POWER¥SWITCH] button to turn off the
power.
2.5A
POWER
SWITCH
PEDAL
C-190 Portable Organ

Adjusting the volume

The C-190 has three sliders. The [VOLUME] slider is used
to change the global volume. The [PEDAL] slider allows
you to set the level of the bass sounds.
VOLUME PEDAL
Global volume (all Volume of the bass
sections). tone.
Using the [PEDAL] and [MANUAL¥I] sliders should allow
you to create the right balance – even when using the
MANUAL II section.
By purchasing an optional EV-5, EV-7 or BOSS FV-300L
expression pedal, which you connect to the EXP/SUST
socket, you can also set the MANUAL II division's vol-
ume (and/or use the pedal for swelling effects).
Connecting headphones (sold
separately)
The C-190 features two headphone jacks. This allows
two people to listen through headphones simulta-
neously, making it very useful for lessons. Using head-
phones allows you to play without bothering others
around you, even at night.
(1) Turn the volume all the way down.
(2) Plug a pair of headphones (Roland RH-25, RH-50,
RH-200) into a PHONES socket to the left of the
C-190's keyboard.
(3) Adjust the volume.
By connecting headphones to the C-190, you switch
off its speakers, which is ideal for playing or practis-
ing without disturbing others.
Note: Be sure to use stereo headphones.
Precautions to take when using headphones
To avoid damaging or severing the headphone cord, be
sure to handle the headphones by holding the phones
themselves, and grasping the plug rather than the cord
when pulling the headphone plug.
• Connecting the headphones when the volume of
connected equipment is turned up may result in
damage to the headphones. Be sure to turn down the
volume before connecting headphones.
r
Connecting the adapter
MANUAL I
Volume of the
MANUAL I division.
9