Call Tones; Key-Tone On/Off - Topcom RC-6406 Manual De Instrucciones

Ocultar thumbs Ver también para RC-6406:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 41
TT 9500 Airsoft Edition.book Page 9 Monday, January 14, 2013 4:28 PM
Twintalker 9500 (RC-6406) Airsoft Edition
13.10.3 Scanning for a DCS code
Press the
"SCAN" and "DCS 00" flashes on the
display for the selected radio channel.
Press the
button
10
Once there is a transmission on the channel, the DCS code (if used) will
be detected and displayed.
If you press the
button
PTT
found DCS code, the PMR will go back in stand-by mode
on the channel with the DCS code.

13.11 Call Tones

A call tone alerts others that you want to start talking.
13.11.1 Setting the Call Tone
The Twintalker 9500 (RC-6406) has 15 call tones.
Press the
"C" is displayed and the current call tone
is flashing.
Press the
button
10
Tone.
Press the
PTT
and return to stand-by mode.
13.11.2 Sending a call Tone
6
Press the
button
briefly. The call tone will be transmitted on the
set channel.
13.11.3 Call tone reception type
Press the
-button
7
nine times.
Press the
-button
or
-button
11
reception type.
1.
2.
-button
7
seven times :
3.
-button
or the
-
11
to start the DCS scan.
13.12 Roger Beep On/Off
After the
to confirm that you have stopped talking.
while listening to a
12

13.13 Key-Tone On/Off

- button
7
eight times,
When a button is pressed, the unit will beep briefly.
- button
or the
-
11
to change to another Call
- button
to confirm
12
13.14 Dual Channel Monitor function
In stand-by, the PMR is set on one channel with CTCSS/DCS code. The
PMR will only receive signals transmitted on that channel with the
CTCSS/DCS code.
10
to select the call tone
Tone only
Tone + vibration
Vibration only
Press the
-button
to confirm and return to stand-by mode.
12
PTT
-button
is released, the unit will send out a roger beep
PTT
12
To set the Roger Beep.
•Press the
- button
displayed.
•Press
button
11
button
10
to disable the Roger-Beep (OFF).
•Press the
- button
PTT
selection and return to the
standby mode.
To set the key-tone.
7
•Press
button
displayed.
•Press
button
11
button
to disable the Key Tones (OFF).
10
•Press the
- button
PTT
selection and return to the standby mode.
9
7
ten times. 'rO' will be
to enable (ON) or
to confirm your
12
eleven times. 'tO' will be
to enable (ON) or
to confirm your
12

Publicidad

Tabla de contenido
loading

Tabla de contenido