Mitsubishi Electric Mr. Slim PCA-RP50KAQ Para El Instalador página 9

Fig. 6-4
Fig. 6 - 5
MODEL SELECT
ON/OFF TEMP
FAN AUTO STOP
MODE VANE AUTO START
CHECK LOUVER h
TEST RUN min
SET RESET CLOCK
Fig. 6-7
3) 2 remote controllers setting
If 2 remote controllers are connected, set one to "Main" and the other to "Sub". For
A B TB 6
setting procedures, refer to "Function selection of remote controller" in the opera-
tion manual for the indoor unit.
1) Installation area
• Area in which the remote controller is not exposed to direct sunshine.
MODEL SELECT
• Area in which there is no nearby heating source.
• Area in which the remote controller is not exposed to cold (or hot) winds.
• Area in which the remote controller can be operated easily.
• Area in which the remote controller is beyond the reach of children.
ON/OFF TEMP
FAN AUTO STOP
MODE VANE AUTO START
CHECK LOUVER h
• The signal can travel up to approximately 7 meters (in a straight line) within 45
TEST RUN min
SET RESET CLOCK
Fig. 6-6
Each unit can be operated only by the assigned remote controller.
Make sure each pair of an indoor unit PC board and a remote controller is assigned
to the same pair No.
5) Wireless remote controller pair number setting operation
Connect the remote controller cord to the terminal block.
To TB5 on the indoor unit
TB6 (No polarity)
Attach the remote controller holder to the desired location using 2 tapping screws.
Place the lower end of the controller into the holder.
Remote controller Wall Display panel
degrees to both right and left of the center line of the receiver.
Insert batteries.
Press the SET button with something sharp at the end.
blinks and Model No. is lighted.
MODEL SELECT
Press the temp buttons to set the Model No.
If you mistook the operation, press the ON/OFF
from procedure .
Press the SET button with something sharp at the end.
and Model No. are lighted for 3 seconds, then turned off.
MODEL SELECT
Indoor Outdoor
PUH, PUHZ, SUZ
PCA
PU
Press the SET button with something sharp at the end.
Start this operation from the status of remote controller display turned off.
blinks and Model No. is lighted.
MODEL SELECT
min
Press the button twice continuously. Pair No. "0" blinks.
Press the temp buttons to set the pair number you want to set.
If you mistook the operation, press the ON/OFF
from procedure .
Press the SET button with something sharp at the end.
Set pair number is lighted for 3 seconds then turned off.
Pair No. of wireless remote controller
0
1
2
3-9
Receiver
button and operate again
Model No.
001
033
button and operate again
Indoor PC board
Initial setting
Cut J41
Cut J42
Cut J41, J42
9