Before using for the fi rst time
General information
• Only use pure water without
carbonation.
• Use the supplied test strip to determine
the hardness of the water used and set
the water hardness („Water hardness
and fi lter", page 18).
Information for using for the fi rst
time
The appliance must be vented before
it is used for the fi rst time. To do so,
the appliance may only be switched on
without a Melitta
®
with a completely fi lled water reservoir.
• Place a vessel under outlet 2.
• Press the
button to switch on the
appliance.
illuminates on the display.
• Press the
button. Water will be
pumped through the system.
• The appliance is ready for operation
when
illuminates on display 9.
• After using the appliance for the fi rst
time, insert the Melitta
fi lter if required (see page 19).
BA_Solo_042015.indd 17
BA_Solo_042015.indd 17
Claris
water fi lter and
®
Claris
water
®
®
Starting up the appliance
Starting up
Warning!
Danger of fi re and electric shock
due to incorrect supply voltage,
incorrect or damaged connections
and power cable.
– Ensure that the supply voltage
corresponds to the supply voltage
specifi ed on the identifi cation label of
the appliance. The identifi cation label is
located on the right side of the appliance
behind the cover (Image A, 11).
– Make sure that the power socket meets
the applicable standards for electrical
safety. If in doubt, contact a qualifi ed
electrician.
– Never use damaged power cables
(damaged insulation, bare wires).
• Place the appliance on a stable, dry and
level surface with suffi cient clearance (at
least 10 cm) to the sides.
• Plug the power cable into a suitable
power socket.
• Remove the lid from the bean container
7.
• Fill the bean container with suitable
coffee beans.
• Put the lid back on.
• Raise the lid of the water reservoir 6 and
pull the water reservoir up and out of the
appliance.
• Fill the water reservoir with fresh tap
water only up to the max. mark.
17
20.04.2015 21:30:46
20.04.2015 21:30:46