IMG STAGELINE LE-212 Manual De Instrucciones página 7

4) Install the new lamp: slightly loosen the two screws
at the lamp socket, tightly clamp one spade lug each
of the connection cable below each screw, and tight-
en the two screws again. Carefully place the lamp
into the spot light housing.
5) Place the colour filter (b) on the lamp, and screw on
the screw cover (a) again.
a
b
4 Mounting
Fix the light effect unit with two (models LE-212 and
LE-222) resp. four (model LE-232) stable mounting
screws at the desired place (e. g. at the ceiling or two
parallel traverses).
Important! To avoid a heat accumulation in the unit,
the mounting place must be chosen so that sufficient
Model Voltage Supply
LE-212 230 V~/50 Hz
LE-222 230 V~/50 Hz
LE-232 230 V~/50 Hz
air circulation is secured during operation. The vents of
the housing must not be covered.
5 Operation
5.1 Models LE-212 and LE-222
After mounting connect the unit with the mains plug to
a mains socket (230 V~/50 Hz). With connection to the
power supply the unit is switched on: the radiating
parts start to rotate. To switch off the unit, disconnect
the mains plug.
5.2 Model LE-232
1) Connect the light effect unit with the mains plug to a
2) Adjust the desired volume at the music system. The
3) Adjust the desired microphone sensitivity with the
c
Model LE-232:
lamp replacement
4) To vary the light effect, the inclination angle can
5) For switching off the unit disconnect the mains plug.
Specifications
Power Consumption
2 halogen lamps (230 V/150 W,
300 VA
socket GX 6,35 or GY 6,35)
2 halogen lamps (230 V/150 W,
300 VA
socket GX 6,35 or GY 6,35)
4 lamps of type PAR 36
150 VA
(6 V/30 W, socket: 2 x screw)
mains socket (230 V~/50 Hz). With connection to
the power supply the unit is switched on: the four
spot lights radiate.
unit receives the music via the installed microphone
located directly beside the rotary control: the mirror
pyramid in the centre starts to rotate to the beat of
the music.
rotary control. If the control is turned counterclock-
wise until it stops, the microphone is switched off.
The further the control is turned up clockwise, the
higher the microphone sensitivity becomes. Adjust
the control so that the dynamic range of the music
is reproduced by the dancing light beams in an opti-
mum way.
NOTE: When changing the volume at the music
system, the microphone sensitivity must be accord-
ingly matched as well.
individually be adjusted at each of the spot lights via
the setscrew [(c) in the fig.].
Important! The spot lights heat up very much during
operation. Therefore, after longer operation switch
off the unit by disconnecting the mains plug, and at
first let the spot lights sufficiently cool down before
adjusting their inclination angles.
Lamp Inserts
According to the manufacturer
Subject to change.
GB
DImensions/
Weight
45 x 34 x 19 cm/
4 kg
36 x 37 x 24 cm/
4 kg
31 x 27 x 24.5 cm/
6 kg
7