Customer Information - 3M ESPE Elipar DeepCure-L Instrucciones De Uso

3. Removing the Battery for Disposal
To dispose of the battery, disconnect the Elipar LED
curing light from the charger, remove the two screws on
each side of the charging socket and push the lower
half of the housing towards the back, away from the
upper half of the housing. Use a suitable tool to cut the
connecting wires between the battery and the circuit
board and remove the battery for disposal in accordance
with 1. and 2.
4. Meaning of the Symbols
The EU Directive prohibits the disposal of any electric or

Customer Information

No person is authorized to provide any information that
deviates from the information provided in this instruction
sheet.
Warranty
3M Deutschland GmbH warrants this product will be free
from defects in material and manufacture. 3M Deutsch-
land GmbH MAKES NO OTHER WARRANTIES INCLUDING
ANY IMPLIED WARRANTY OF MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE. User is
responsible for determining the suitability of the product
for user's application. If this product is defective within
the warranty period, your exclusive remedy and
3M Deutschland GmbH's sole obligation shall be repair
or replacement of the 3M Deutschland GmbH product.
Limitation of Liability
Except where prohibited by law, 3M Deutschland GmbH
will not be liable for any loss or damage arising from
this product, whether direct, indirect, special, incidental
or consequential, regardless of the theory asserted,
including warranty, contract, negligence, or strict liability.
Information valid as of October 2014
10
electronic devices marked
with these symbols in
combination with household
waste.