Mounting - Fagor 3MWB-44BTCGB Manual De Instrucciones

MOUNTING

1. The appliance is designed for household use only.
2. This oven is intended for installation in a cabinet only. It is not intended to oper-
ate as a free-standing appliance on a countertop or for use inside cabinets.
3. The cabinet cannot have a back wall. At the back of the appliance there must
be sufficient gap to allow the air flow
4. The rear edge of the base/installation shelf must be mounted at least 100 mm
from the wall (there must be a gap behind the appliance)
5. The cabinet must have a vent at the front of at least 250cm
Notes:
• Vents and air-flow gap cannot be covered.
• The correct operation of the appliance is guaranteed by proper installation in
the cabinet.
• The cabinets must be made of materials resistant to high temperatures (up to
90 C).
O
• The appliance is equipped with a plug and may be connected only to a prop-
erly installed wall outlet with a protective earthing, the plug must be easily
accessible after the appliance is properly installed.
• Mains voltage must correspond to the voltage indicated on the nameplate.
• The use of adapters, splitters or extension cords is not allowed. Overloading
may cause fire.
68
.
2