Tabla de contenido
Publicidad
Vibration Reduction (VR)
En
Vibration reduction (VR) reduces blur caused by camera
shake, allowing shutter speeds up to four stops slower than
would otherwise be the case (Nikon measurements; effects
vary with the photographer and shooting conditions). This
increases the range of shutter speeds available and permits
hand-held, tripod-free photography in a wide range of
situations.
Using the Vibration Reduction ON/OFF Switch
Using Vibration Reduction: Notes
•
Slide the vibration reduction switch to OFF if the camera
does not support vibration reduction (pg. 16). Leaving
vibration reduction on may greatly increase the drain on
the battery, particularly in the case of Pronea 600i/6i
cameras.
•
When using vibration reduction, press the shutter-release
button halfway and wait for the image in the viewfinder to
stabilize before pressing the shutter-release button the rest
of the way down.
•
When vibration reduction is active, the image in the
viewfinder may be blurred after the shutter is released. This
does not indicate a malfunction.
18
Select ON to enable vibration reduction. Vibration
reduction is activated when the shutter-
release button is pressed halfway, reducing
the effects of camera shake for improved
framing and focus.
Select OFF to turn vibration reduction off.
Publicidad
Tabla de contenido
