Tabla de contenido
Publicidad
•
When the camera is panned, vibration reduction applies
only to motion that is not part of the pan (if the camera is
panned horizontally, for example, vibration reduction will
be applied only to vertical shake), making it much easier to
pan the camera smoothly in a wide arc.
•
Do not turn the camera off or remove the lens while
vibration reduction is in effect. If power to the lens is cut
while vibration reduction is on, the lens may rattle when
shaken. This is not a malfunction, and can be corrected by
reattaching the lens and turning the camera on.
•
If the camera is equipped with a built-in flash, vibration
reduction will be disabled while the flash charges.
•
Slide the vibration reduction switch to OFF for long time-
exposures.
•
Turn vibration reduction off when the camera is securely
mounted on a tripod, but leave it on if the tripod head is
not secured or when using a monopod.
The Lens Hood
The lens hoods protect the lens and block stray light that
would otherwise cause flare or ghosting.
When attaching or removing the hood, hold it near the
symbol on its base and avoid gripping it too tightly.
Vignetting may occur if the hood is not correctly attached.
The hood can be reversed and mounted on the lens when
not in use. When the hood is reversed, it can be attached and
removed by rotating it while holding it near the lock mark
(— ).
Align the lens hood lock mark (— )
with the lens hood mounting mark
( ) on the lens (e).
En
19
Publicidad
Tabla de contenido
