Accessories; Magnetic Tape; Cover Strip; Installation Aid Bam To-Ml-006-S1G (Order Code Bam0256) - Balluff BML SL1-ALZ1-B0ZZ-ABA1-S284/KA Manual De Instrucciones

BML SL1-ALZ1- _ _ ZZ -ABA _ - S284/KA _ _
Absolute magnetic encoder system
9

Accessories

Accessories are not included in the scope of delivery and
must be ordered separately.
Additional accessories can be found at
www.balluff.com.
9.1

Magnetic tape

Measuring range = length – 6 cm
Ballu JJWW ._ _DE Abs Code L
Length
(0.07...8.19 m)
Fig. 9-1: Magnetic tape dimensions
BML TSC-ALCZ-1_ZZ-M_ _ _ _
Thickness

Cover strip

C = Thickness 1.55, Z = none
3 = with
comes with an
(see Section 9.2)
adhesive layer
(with protective film)
for fastening
Preferred types
BML TSC-ALCZ-1ZZZ-M0100
BML TSC-ALCZ-1ZZZ-M0819
BML TSC-ALCZ-1ZZZ-M2400
For a complete technical description and
assembly instructions for magnetic tapes,
please see the magnetic tape user's guide on
the Internet at www.balluff.com.
9.2 Cover strip
To protect the magnetic tape from damage caused by
chips or chemicals, you may cover it using a stainless steel
cover strip. Note that the permissible gap (see Tab. 4-2 on
page 11 and Tab. 4-3 on page 12) between head and
tape is reduced by the thickness of the cover strip with
adhesive layer (0.15 mm).
Before affixing the cover strip, carefully clean the surface of
the magnetic tape (acetone, turpentine, mild plastic
cleaner, no benzine).
www.balluff.com
e L
10+0.2
1.55±0.1
Length
in cm
Order code Length
BML074F 1 m
BML074E 8.19 m
BML074H 24 m
The cover strip can be ordered in 4 defined lengths on a
roll.
Preferred types Order code
BML-A013-T0500 BML001J
BML-A013-T1000 BML001K
BML-A013-T2400 BML001L
BML-A013-T4800 BML001M
For a complete technical description and
assembly instructions for cover strips, please see
the magnetic tape user's guide on the Internet at
www.balluff.com.
9.3 Installation aid BAM TO-ML-006-S1G
(order code BAM0256)
56.5
32
25
3.5
Fig. 9-2: Installation aid
9.4 Installation accessories BAM TO-ML-014-01
(order code BAM02YC)
The installation accessories consist of screws, insulators,
washers, drill template, clearance gauge and pole pitch
display card.
9.5

BML Configuration Tool BAE PD-ML-010-03

Use with BML SL1 with BiSS- or SSI Interface.
Order code: BAE00UN
You can use the Configuration Tool to read the
measurement value, signal quality and error messages
from the sensor head and precisely set the offset of the
sensor head. Other parameters such as direction of the
position output can be set and you can toggle between
SSi and BiSS.
Length
5 m
10 m
24 m
48 m
4.2
75
english 23