CAUTIONS REGARDING HANDLING
Location
Install the player in a well-ventilated location where it
will not be exposed to high temperatures or humidity.
Do not install the player in a location which is exposed to direct
rays of the sun, or near stoves or radiators. Excessive heat can
adversely affect the cabinet and internal components. Also,
installation of the player in a damp or dusty environment may
result in malfunction or accident.
Precautions regarding installation
÷ Placing and using the compact disc player for long periods
on heat-generating sources such as amplifiers or near
spotlights, etc. will affect performance. Avoid placing the
player on heat-generating sources such as amplifiers.
÷ Install this compact disc player as far as possible from
tuners and TV sets. Noise may be particularly noticeable
when an indoor antenna is used. In such cases, make use
of an outdoor antenna, or turn off power to the compact
disc player.
÷ When the unit is used in a loud-sound environment, for
example near a speaker, sound skip may occur. In such a
case, install the unit apart from the speaker or reduce the
listening volume.
÷ Please place this unit on a level surface and a stable
flatform.
÷ Besure that the player, including its audio and power
supply cords, dose not touch vibrating materials.
This player has a shock absorber incorporated in the
insulators to absorb vibration. Any other cause of vibration,
other than the insulators, may cause the disc to skip.
Do not place on or against
vibrating materials!
D
|
Cleaning the player
To clean the PLAYER, wipe with a soft, dry cloth. For stubborn
dirt, wet a soft cloth with a mild detergent solution made by
diluting one part detergent to 5 or 6 parts water, wring well,
then wipe off the dirt. Use a dry cloth to wipe the surface dry.
Do not use volatile liquids such as benzene and thinner which
are harmful to the unit.
4
<DRB1222>
En
Storing discs
Be careful not to allow discs to warp; always store discs in
their cases vertically, avoiding locations with high heat or
humidity, or extremely low temperatures.
CD lens cleaner
The player's pickup lens should not become dirty in normal
use, but if for some reason it should malfunction due to
soiling, consult your nearest PIONEER authorized service
center.
Lens cleaners for CD players are commercially
available, but special care should be exercised in their use
since some may cause damage to the lens.
Condensation
When this unit is brought into a warm room from previously
cold surroundings or when the room temperature rises sharply,
condensation may form inside, and the unit may not be able
to attain its full performance. In cases like this, allow the unit
to stand for about an hour or raise the room temperature
gradually.
Cleaning and handling compact discs
÷ Always keep your discs clean by wiping them gently with
a soft cloth from the inner edge toward the outer periphery.
÷ If a disc becomes very dirty, dip a soft cloth in water, and
after wringing it out well, wipe the dirt away gently, and
then remove any water drops with another soft, dry cloth.
÷ Do not use record cleaning sprays or antistatic agents on
discs. Also, never clean discs with benzene, thinner, or
other volatile solvents, since damage to the disc surface
may result.
÷ With this player, use discs which display the mark shown
below. (Optical audio digital discs.)
÷ When holding discs, do not touch their signal surfaces (the
side reflecting a "rainbow" pattern, opposite the label side).
Hold by the edges, or by one edge and the center hole.
÷ Do not affix gummed labels or tape to the label surfaces.
Also, do not scratch or damage the label.
÷ Discs rotate at high speed inside the player. Do not use
damaged (cracked or warped) discs.
'