Corghi HD 900 Manual De Uso página 45

M Tool holder arm release pedal
N Carriage
O Tool holder arm
S Second speed switch
See fig.10.
P Control lever
Q Turntable opening/closing control
R Turntable rotation pedal
P
R
Start the machine with the main switch (A, Fig.
9) and make sure that the hydraulic power unit
motor is rotating in the direction indicated by
the arrow (A, Fig. 11) which can be seen on the
motor cap.
- E - Operator's manual HD 900
nglIsh
Otherwise, the rotation direction must be cor-
rected immediately in order not to damage the
pump unit.
All machine parts are powered by low voltage
(24V), with the exception of the hydraulic power
unit and the turntable rotation motor, which are
powered with mains voltage.
WARNING
Make sure that all parts of the hydraulic cir-
cuit are tightened correctly. If pressurised oil
escapes, it can cause serious injury.
WARNING
The machine is equipped with devices that
guarantee the operator's safety:
1) Check valve on the turntable opening line
(located inside the swivel connector, see Fig.
12A).
Q
Prevent the wheel from falling due to accidental
breakage of the oleodynamic circuit.
2) Dual seal, pilot-operated check valve (see
Fig.12B).
Prevent the turntable holder arm from falling
suddenly in the case of accidental breakage to
the oleodynamic circuit.
10
A
WARNING
To prevent accidents when using the included
or optional accessories, make sure that the
mechanical parts have been correctly installed
and well fixed to the parts.
When working, firmly grip the manual acces-
sories.
11
12B
UK
12A
45