Corghi HD 900 Manual De Uso página 56

dot is positioned 3 cm inside the rim.
17) Insert the bead lifting lever between the
rim and the bead to the right of the tool (see
Fig. 28).
18) Keeping the lever pressed down, lower the
wheel to bring the rim edge about 5 cm from the
hook tool, then turn the wheel anticlockwise
until the tyre comes completely off the rim.
WARNING
When the beads come off the rim, the
tyre will fall.
Make sure no one is in the work area.
MOUNTING
1) If the rim has been removed from the turn-
table, reclamp it as described in the "WHEEL
CLAMPING" paragraph.
2) Lubricate the tyre beads and rim using the
recommended soapy solution.
3) Tighten the rim gripper on the outer side of
the rim at the highest point (see fig. 29).
56
Make sure that the gripper is well at-
tached to the rim.
4) Move the mobile control unit to work-
ing position B.
28
5) Position the tyre on the platform and lower
the turntable (making sure to keep the gripper
in the highest point) to hook the first bead to
the gripper.
6) Lift the rim with the tyre hooked to it and turn
it anticlockwise about 15-20 cm. The tyre will be
positioned tilted across the rim.
7) Move the tool holder arm to the non-working
position; move it to the inner side of the tyre
and rehook it in this position.
8) Make sure that the hook tool is positioned
to the side of the wheel.
Otherwise, press the tool rotation lever and
turn it 180°.
9) Move the mobile control unit to work-
ing position D.
10) Move the tool forward so that its red refer-
ence dot is aligned with the external edge of the
rim, 5 mm. away from it (see Fig. 30).
- E
WARNING
- Operator's manual HD 900
nglIsh
29