Operation; Operation Instructions - HOLZMANN MASCHINEN KAP 305JL Manual De Instrucciones

14

OPERATION

Device to be operated in a perfect state only. Inspect the device visually every time it is to be
used. Check in particular the safety equipment, electrical controls, electric cables and screwed
connection for damage and if tightened properly. Replace any damaged parts before operating
the device.
14.1

Operation instructions

Perform all machine settings with the machine being
















HOLZMANN Maschinen GmbH
KAP 305JL
W A R N I N G
disconnected from the power supply!
Do not look directly into the laser beam. Never direct the laser
beam at people or objects other than the workpiece.
Do not deliberately point the laser beam at people.
Only point the laser beam at insensitive workpieces with a dull
surface. Wood or rough surfaces are ideal for this. Shiny, reflective
surfaces are not suitable for using a laser since the laser beam
could be directed at the user by the reflective surfaces.
Always switch off the laser when you have finished work at the
ON/OFF switch for the laser light (38).
Only switch on the laser beam if there is a workpiece on the mitre
saw bench
Do not use damaged or warped saw blades.
Replace the worn table insert.
Select the appropriate saw blade for the material to be cut.
Warning! Protective equipment must not use for the purpose of
transport
Use the saw only if the safety devices are functional, in good
condition and in the provided position.
Do not remove offcuts or other workpiece parts from the sectional
area, as long as the machine with unprotected blade is moving.
The workpiece must always be clamped to the saw table.
Before each cutting operation make sure that the machine stands
safely.
Mark the cutting line on the workpiece.
Set the angle of the cutting operation.
To make a cut from the workpiece hold the laser along the marked
line.
www.holzmann-maschinen.at
A T T E N T I O N
N O T I C E
OPERATION
41