Modes; Angle Settings - HOLZMANN MASCHINEN KAP 305JL Manual De Instrucciones

14.2

Modes

14.2.1 Angle settings

Tilt adjustment:
 Loosen the fixing knob (18).
 Set the saw arm in order that the tilt angle indicator (36) points exactly at 0° of the
measuring scale (19).
 Fix the saw arm in this position by tightening the fixing knob (18).
 Bring the saw arm into the lower position and lock it with the interlock knob (23).
 Attach an exact angle measuring device to saw blade side and ground plate. They should
have an exact angle of 90°.
 If not, then you need to adjust the 0° of the saw arm by adjusting it with the saw arm
adjustment screws (N - 37).
 Repeat the procedure until 0° on indicator is exactly 90° between saw blade and ground
plate.
Swing angle adjustment:
 Loosen the fixing knob (3), operate the fixing lever (4) and swing the saw arm aggregate
to the 0° position, let it click into place. You can see the angle at the measuring scale (5).
 Swing the saw arm into the lower position and lock it with the interlock knob (23).
 Attach an exact angle measuring device to saw blade side and the left back fence (1).
They should have an exact angle of 90°.
 If not, you need to adjust the back fence guide with the back fence adjustment screws
(20) so that angle between saw blade and fence equals 90°.
 Repeat the procedure with the right side back fence.
Adjust the cutting depth
Finally you need to check the cutting depth of the saw.
Swing the saw arm down into lowest possible position and check if it
touches the ground plate.
The depth stop should be already preset so that the blade reaches
into the cutting line slit (2) but has a distance to the ground plate of
at least 5mm.
If necessary adjust the depth stop pin (27).
Laser
The Laser marks the cutting line. After having set all angles and cutting depth, you should fine-
tune your laser.
Attach the workpiece to the back fence, fix it with the downholder.
Perform a slot cut on the workpiece so that it gets not cut through entirely.
(See point 5, Slot cut adjustments see point 5.3.3)
Now turn on the laser (ON/OFF Switch 38) and check if the laser beam marks exactly the real
cutting line.
If not you need to adjust the whole laser assembly until laser indication matches exactly the
actual cutting line.
HOLZMANN Maschinen GmbH
KAP 305JL
www.holzmann-maschinen.at
OPERATION
42