Night Light; Battery Replacement - TFA 60.2559.54 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 31
TFA_No. 60.2559_Anleitung
SONIO 2.0 – Radio-controlled alarm clock with thermometer
• If the alarm is not stopped manually, the alarm tone automatically turns off
after two minutes and will be reactivated at the same set time in the following
day.
• You can activate the snooze function by pressing the LIGHT/SNOOZE button on
the top.
• The snooze symbol will be flashing and the alarm will be interrupted for
5 minutes.
• The snooze function can be activated up to 10 times.
8. Light
• Press the LIGHT/SNOOZE button. The backlight turns on for 6 seconds.

8.1 Night light

• As soon as the batteries are installed the night light for the display is activat-
ed
appears on the display.
• A weak backlight turns on automatically as soon as the light sensor registers
darkness.
• Press the + button for 3 seconds to deactivate the function.
disappears.
9. Care and maintenance
• Clean the instrument with a soft damp cloth. Do not use solvents or scouring
agents.
• Remove the batteries if the device will not be used for an extended period of
time.
• Store the device in a dry place.
22
01.07.2020
12:24 Uhr
Seite 12
SONIO 2.0 – Radio-controlled alarm clock with thermometer

9.1 Battery replacement

• Change the batteries when the display starts to fade or the alarm tone
declines.
• Open the battery compartment at the bottom of the instrument and insert two
new batteries 1,5 V AA. Make sure the polarities are correct. Close the battery
compartment again.
10. Trouble shooting
Problem
Solution
➜ Ensure the batteries' polarities are correct
No display
➜ Change the batteries
➜ Activate DCF reception in setting mode
Symbol
is missing
(No DCF reception)
(DCF ON)
➜ Press and hold the – button for 3 seconds and
start the initialisation manually
➜ Wait for an attempt reception during the night
➜ Choose another place for your product
➜ Set the clock manually
➜ Check if there is any source of interference
➜ Restart the instrument according to the manual
➜ Change the batteries
Incorrect indication
If your device fails to work despite these measures, contact the retailer where
you purchased the product.
23

Publicidad

Tabla de contenido
loading

Tabla de contenido