Time Zone Setting; Time Display; Alarm Time Setting - TFA 60.2559.54 Instrucciones De Uso

TFA_No. 60.2559_Anleitung
SONIO 2.0 – Radio-controlled alarm clock with thermometer
• DCF appears on the display and ON will be flashing.
• By default, the DCF reception is activated (DCF ON) and after successful
reception of the DCF signal no manual adjustment is necessary.
• Press the + or – button if you want to deactivate the DCF reception (DCF OFF).
• Once the DCF time reception is deactivated the clock and date must be manu-
ally set. No time zone appears.
• Confirm the setting with the MODE button.
• Now you can make the settings in the following sequence: The time zone
(ZONE 0 - default), the alarm volume 1-3 (LOUD 2 - default), the hours, the
minutes, the year, the month and the day. Press the + or – button to adjust it.
• Confirm the settings with the MODE button.
• If the DCF reception is activated (DCF ON), the manually set time will be over-
written by the DCF time when the signal is received successfully.

7.1.1 Time zone setting

• In the setting mode you can make the time zone correction +9/-9).
• The time zone correction is needed for countries where the DCF signal can be
received but the time zone is different from the DCF time (e.g. +1=one hour
plus).

7.1.2 Time display

• Press the + button in normal mode to choose between 24- and 12 HR system
(AM or PM appears on the display).
7.2 Indication of temperature-alarm time
• Each press on the MODE button in normal mode will change the display
between:
20
01.07.2020 12:24 Uhr Seite 11
SONIO 2.0 – Radio-controlled alarm clock with thermometer
• Indoor temperature
• ALARM 1
• ALARM 2

7.3 Alarm time setting

• Select your respective alarm function with the MODE button or the ALARM
or buttons:
• AL 1 (default 6:00)
• AL 2 (default 7:00)
• Set the alarm time in the respective alarm mode.
• Press and hold the ALARM or ALARM
• The hour digits flash.
• Press the + or – button to set the desired time.
• Confirm with the respective ALARM button.
• Set the minutes in the same way.
• Confirm with the respective ALARM button.
• To activate or deactivate the alarm function press the respective ALARM but-
ton in normal mode.
• , , + or no alarm symbol will appear on the display.
• In setting mode (see: Manual setting of the clock and calendar), you can
adjust the alarm tone volume in 3 steps.
• When the alarm time is reached, the alarm tone will sound at the selected
volume level and increase gradually in frequency.
• The corresponding alarm symbol
button flashes in red.
• Press any button (except LIGHT/SNOOZE) and the alarm will stop.
button for 3 seconds.
or flashes and the LIGHT/SNOOZE
21