How To Operate With Your Transceiver; Frequency Band Selection; Frequency Band Chart - Midland Alan 48 Pro Manual De Instrucciones

REPLACING FUSE
If you replace the fuse for DC power Cord, use F 2A 250V type. The parameters
and the symbol of the fuse are indicated in the following label.
F2A 250V +
HOW TO OPERATE WITH
YOUR TRANSCEIVER
1. Screw the microphone plug into the microphone jack.
2. Make sure your antenna is securely connected to the antenna connector.
3. Make sure the SQUELCH control is turned fully counterclockwise.
4. Turn on the unit and adjust the volume control.
5. Select your desired channel.
6. To transmit, press the PTT button and speak in a normal tone of voice.
7. To receive, release the PTT button.

FREQUENCY BAND SELECTION

The frequency bands must be chosen according to the country where you are
going to operate.
Procedure:
Switch off the unit.
1.
Turn it on while pushing the "AM/FM" e "SCAN" buttons at the same
2.
time.
3. Rotate the "CHANNEL" knob and select the desired frequency band
(see the chart).
To stop your selection, press the "AM/FM" button.
4.
In the UK frequency band, you can select directly the I band by pushing
NOTE :
1
the "AM/FM" button for 2 seconds.
If you select a frequency band which operates in FM mode only, the
NOTE :
2
"AM/FM" control enables the LCR function (Last Channel Recall).

FREQUENCY BAND CHART

Digits displayed Country
I Italy 40 CH AM/FM 4Watt
I2
Italy 34 CH AM/FM 4Watt
D4 Germany 80 CH FM 4Watt / 40 CH AM 4 Watt
EU Europe 40 CH FM 4Watt / 40 CH AM 1Watt
EC 40 CH FM 4Watt
E Spain 40 CH AM/FM 4Watt
F France 40 CH FM 4Watt / 40 CH AM 1Watt
Poland 40 CH AM/FM 4Watt
PL
England 40 CH FM 4 Watt English frequencies + I
UK
Italy 40CH AM/FM 4W
ATTENTION!
The frequency band definitely allowed all over Europe is 40CH FM 4W (EC).
5