Threading The Needle - EURO-PRO 473 Manual De Instrucciones

THREADING THE NEEDLE

Install the spool pin behind the machine
(as shown in fig A).
Place spool on spool pin, with thread
coming from the back of the spool. Place
the take - up lever 5
position.
1. Raise the presser foot using the foot lever
marked B .
2. Draw the thread through the thread
guides on the top cover as shown in Fig. 1 & 2.
3. Hold the spool still with right hand, pull
the end of the thread between the
tension disk as shown in Fig. 3 . ¢ Û
4. Following the slotted threading path,
pull the thread down to the thread check
spring (inside) and lead it across from
left to right.
5. Pull the thread upward and slip into
the slotted hole of thread take-up level
from left to fight
5
.
6. Draw the thread through guides
and thread the needle from front to
7 ,
rear , leave the thread about 15cm(6
8
inches) long underneath the presser
foot.
in the highest
6, 7, 8
fig A
. ¢ Ù ¢ Ú
and
6
1
3
2
1
3
4
10
2
5
B
4
B
5
A
6
7
8