Key length:
Network key:
Obtain IP address automatically: The IP address, subnet mask, and address for the default gateway are
Use the following IP address:
Use the following DNS server address:
Primary DNS server:
Secondary DNS server:
Accept the settings by pressing "SAVE" or cancel them by pressing "Cancel".
WPS (TVIP10055B only)
WPS (Wi-Fi Protected Setup) is a simple method for establishing a secure wireless network connection
(WPA, WPA2). Consult the manual for your access point (e.g. router with WPS function) regarding the
necessary steps for setting up the WPS function.
WPS:
MAC address:
IP address:
Configure via:
With WEP only. Select the bit length for the key here.
With WEP only. Up to four keys can be assigned.
obtained automatically from a DHCP server. An activated DHCP server
must be present in the network in this case.
Manual setting of the IP address, subnet mask, and standard router
(gateway)
Enable the WPS function here if required.
Shows the MAC address of the wireless interface.
The set IP address is displayed here. The address can be assigned automatically
(DHCP) or manually (see below).
PBC:
Push Button Configuration – You set up a secure wireless connection by pressing
the button on the access point or network camera.
PIN:
If the DNS server address is not automatically assigned by
a DHCP server, it can be manually assigned here.
First server address with which the camera attempts to
convert DNS names into IP addresses.
Alternative server address with which the camera attempts
to convert DNS names into IP addresses.
26