Bosch 4100 Instrucciones De Funcionamiento página 28

Ocultar thumbs Ver también para 4100:
Tabla de contenido

Publicidad

ATTACHING
THE GUARD ASSEMBLY
8. With one hand, hold the front of the barrier guard assembly 4
by the metal "fork". With the other hand, hold the guard release
lever 5 up (Fig. 7).
9. Lower the rear of guard assembly and slip the cross bar 6 into
the rear notch 7 on top of the riving knife 2 (Fig. 7).
10. Lower the front of the guard assembly 4 until the metal "fork"
is parallel with the table (Fig. 8).
11. Press down on the guard release lever 5 until you feel and
hear it snap into the locking
position.
Check that the guard
assembly is securely connected (Fig. 8).
\
/
/
/
ATTACHING
THE ANTI-KICKBACK
DEVICE
12. Attach the Anti-Kickback
Device 7 into the flat recessed
area 8 of the riving knife 2 (Fig. 9).
13. Squeeze the compression
pads 9 while nesting the device
into the flat area (Fig. 9).
14. Release the compression
pads such that the Anti-Kickback
Device locks onto the riving knife immediately
behind the guard
assembly. Check that the attachment
pin is securely connected
into locking hole. Carefully raise and lower the pawls 10 -when
letting go, the spring-loaded
pawls must come down and contact
the table insert (Fig. 9).
Hint: Position the Anti-Kickback
Device behind the flat recessed
area and slide it towards the front until it drops into the recessed
area - then release the compression
pins.
Note: The two attachments
are independant
of each other, so
the Anti-Kickback
Device can be attached
before the Guard
Assembly.
28.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

4100dg

Tabla de contenido