Sauder 417586 Manual De Instalación página 16

Step 10
Lay one of the BACKS (K) over DRAWER ENDS (C and D),
å
and BRACE (L).
Make equal margins along all three edges of the
å
BACK (K). Push on opposite corners of your unit if needed
to make it "square".
Fasten the BACK (K) to your unit using the NAILS (1N).
å
NOTE: Perforations have been provided for access
å
through the BACK. Carefully cut out the rectangle in the
BACK for proper ventilation of your CPU.
C
Page 16
L
417586
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Edge without holes
K
D
(15 used in this step)
1N
NAIL
www.sauder.com/service