Sauder 417586 Manual De Instalación página 48

Step 38
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the DOOR (M) to the LEFT END (B) as shown in
å
the lower diagram. Use the screws in the HINGES. You
should start each SCREW a few turns before completely
tightening any of them.
Fasten a KNOB (5K) to the DOOR (M). Use a GOLD 1"
å
MACHINE SCREW (50S).
Peel the FELT DISC from the FELT DISC CARD (1M). Stick
å
a FELT DISC on the DOOR where it comes in contact with
the DOOR RIGHT END (A).
See the next step for DOOR adjustments.
å
5K
50S
GOLD 1" MACHINE SCREW
(1 used for the KNOB)
Page 48
1M
B
M
1M
A
417586
Stop
Mounting
screw
Hinge
www.sauder.com/service