Descargar Imprimir esta página

The Brush Motor Or The Suction Motor Doesn't Stop; The Squeegee Doesn't Clean Or Dry Efficiently; The Battery Charger Doesn't Work; The Batteries Do Not Charge Or Do Not Hold A Charge - Comet CPS 45 Manual Del Usuario

Publicidad

conduits.
9.2.7
THE BRUSH MOTOR OR THE SUCTION
MOTOR DOESN'T STOP
 The relay switch is defective.
 Stop the machine, cutting off the main power
supply and disconnecting the main battery connec-
tor, and contact the technical service centre.
9.2.8
THE SQUEEGEE DOESN'T CLEAN OR DRY
EFFICIENTLY
 The squeegee blades are worn or are dragging solid
dirt.
 Replace or clean them.
 The squeegee adjustment is not correct; the
advancement must be exactly perpendicular to the
running direction.
 Adjust the squeegee.
 The suction hose, the squeegee conduit or the
inspection compartment is clogged.
 Clean out and remove any obstructions from the
conduits.
9.2.9

THE BATTERY CHARGER DOESN'T WORK

 The battery charge doesn't start.
 Check that the battery charger is connected to the
battery. Consult the battery charger manual.
9.2.10
THE BATTERIES DO NOT CHARGE OR DO
NOT HOLD A CHARGE
 At the end of the charging process, the battery is
not correctly charged (see the battery manufacturer's
instruction-maintenance manual)
 Check the battery charger error message and check
the data indicated on the display (see the battery char-
ger's instruction manual).
 The batteries are new and do not generate 100% of
the rated performances.
 The accumulator reaches the maximum perfor-
mance after 20-30 complete charge cycles.
 The electrolyte has evaporated and does not
completely cover the plates.
 Check the battery manufacturer's use and mainte-
nance manual.
 There are significant differences in density among
the various elements.
 Replace the damaged battery.
Always consult the battery and battery charger use and
maintenance manual. If this does not solve the pro-
blem, contact the authorised technical service centre.
The manufacturer CANNOT solve problems caused
by using batteries and battery chargers that were
not directly supplied.

10. CONDITIONS OF WARRANTY

All our appliances are subjected to rigorous tests and
are covered by warranty against material or manu-
facturing defects for a period of 12 months. The war-
ranty comes into effect from the date of purchase.
The date of purchase is the date indicated on the
receipt issued by the Reseller when the appliance is
consigned. The manufacturer shall repair or replace
any faulty parts free of charge during the period cov-
ered by the warranty. Any defects, which cannot be
clearly attributed to material or manufacturing de-
fects shall be examined by one of our Technical Ser-
vice Centres or at our factory and charged in accord-
ance with the outcome. The following are anyhow
not covered by the warranty: accidental damage dur-
ing transportation or handling, accidental damage
caused by negligence or unsuitable conduct, dam-
age due to incorrect or improper uses or installations
which do not conform with the warnings included in
the instruction manual, and anyhow due to unusual
events which do not depend on the running or use
of the appliance. Appliances requiring repair must
be delivered at the Technical Service Centre com-
plete with all their original accessories together with
proof of purchase. If the appliance has been repaired
or tampered with by unauthorised third parties, the
warranty shall be considered null and void. The war-
ranty shall also be considered null and void if the
user is not able to produce an original (legible and
complete) document proving purchase or if it not
possible to read the appliance serial number located
on the frame. The appliance shall not be replaced
and the warranty shall not be extended once the ap-
pliance has been affected by a fault. Repairs shall be
carried out at one of our Authorised technical Service
Centres or at our factory. Appliances for repair must
be sent carriage free, that is, the user shall pay and be
responsible for carriage. The warranty does not cover
the cleaning of working parts, any scheduled main-
tenance nor the repair or replacement of parts sub-
ject to normal wear and tear. The manufacturer shall
not be held liable for damage to persons or things
caused by any installation which does not comply
with the instructions in the manual or faulty use of
the appliance.

10.1 SCRAPPING OF THE MACHINE

If the machine will no longer be used, remove the
batteries and dispose of them in accordance with
the eco-compatibility regulations as set forth in Eu-
ropean standard 2013/56/EU or deposit them in an
authorised collection centre.
To dispose of the machine, comply with the current
laws where it is used:
- disconnect the machine from the mains and clean it
after emptying any liquids;
- separate the machine into groups of homogeneous
materials (plastics in accordance with the recycling
39

Publicidad

loading