Insufficient Suction; The Brush Motor Or The Suction Motor Doesn't Stop; The Squeegee Doesn't Clean Or Dry Efficiently; The Battery Charger Doesn't Work - Comet CRS 90 BT Manual De Instrucciones

Tabla de contenido

Publicidad

9.2.6 INSUFFICIENT SUCTION

 The recovery tank cover was not correctly
tightened.
 Tighten it correctly.
 The recovery tank drain hose plug is not per-
fectly
closed.
 Close it correctly.
 The suction hose, the squeegee conduit or the
inspection compartment is clogged.
 Clean out and remove any obstructions from
the conduits.
9.2.7 THE BRUSH MOTOR OR THE SUCTION
MOTOR DOESN'T STOP
 The relay switch is defective.
 Stop the machine, cutting off the main power
supply and disconnecting the main battery con-
nector, and contact the technical service centre.
9.2.8 THE SQUEEGEE DOESN'T CLEAN OR DRY
EFFICIENTLY
 The squeegee blades are worn or are drag-
ging solid dirt.
 Replace or clean them.
 The squeegee adjustment is not correct; the
advancement must be exactly perpendicular to
the running direction.
 Adjust the squeegee.
 The suction hose, the squeegee conduit or the
inspection compartment is clogged.
 Clean out and remove any obstructions from
the
conduits.

9.2.9 THE BATTERY CHARGER DOESN'T WORK

 The battery charge doesn't start.
 Check that the battery charger is connected to
the battery. Consult the battery charger manual.
9.2.10 THE BATTERIES DO NOT CHARGE OR
DO NOT HOLD A CHARGE
 At the end of the charging process, the battery
is not correctly charged (see the battery manu-
facturer's instruction-maintenance manual)
 Check the battery charger error message and
check the data indicated on the display (see the
battery charger's instruction manual).
 The batteries are new and do not generate
100% of the rated performances.
 The accumulator reaches the maximum per-
formance after 20-30 complete charge cycles.
 The electrolyte has evaporated and does not
completely cover the plates.
 Check the battery manufacturer's use and
maintenance manual.
 There are significant differences in density
among
the various elements.
 Replace the damaged battery.
Always consult the battery and battery
charger use and maintenance manual. If this
does not solve the problem, contact the au-
thorised technical service centre.
The manufacturer CANNOT solve problems
caused by using batteries and battery charg-
ers that were not directly supplied.
10.

CONDITIONS OF WARRANTY

All our appliances are subjected to rigorous tests
and are covered by warranty against material or
manufacturing defects for a period of 12 months.
The warranty comes into effect from the date of
purchase. The date of purchase is the date indicat-
ed on the receipt issued by the Reseller when the
appliance is consigned. The manufacturer shall
repair or replace any faulty parts free of charge
during the period covered by the warranty. Any
defects, which cannot be clearly attributed to ma-
terial or manufacturing defects shall be examined
by one of our Technical Service Centres or at our
factory and charged in accordance with the out-
come. The following are anyhow not covered by
the warranty: accidental damage during transpor-
tation or handling, accidental damage caused by
negligence or unsuitable conduct, damage due to
incorrect or improper uses or installations which
do not conform with the warnings included in the
instruction manual, and anyhow due to unusual
events which do not depend on the running or
use of the appliance. Appliances requiring repair
must be delivered at the Technical Service Centre
complete with all their original accessories to-
gether with proof of purchase. If the appliance has
been repaired or tampered with by unauthorised
third parties, the warranty shall be considered null
and void. The warranty shall also be considered
null and void if the user is not able to produce an
original (legible and complete) document proving
purchase or if it not possible to read the appliance
serial number located on the frame. The appliance
shall not be replaced and the warranty shall not
be extended once the appliance has been affect-
ed by a fault. Repairs shall be carried out at one
of our Authorised technical Service Centres or at
our factory. Appliances for repair must be sent car-
riage free, that is, the user shall pay and be respon-
sible for carriage. The warranty does not cover the
cleaning of working parts, any scheduled mainte-
nance nor the repair or replacement of parts sub-
ject to normal wear and tear. The manufacturer
44

Publicidad

Tabla de contenido
loading

Tabla de contenido