Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
4.5) Alarms/Warnings
These appear on the display during operation and inform the operator on the state of the tool.
Message
BATTERY
BATTERY
BATTERY
BATTERY
BATTERY
BATTERY
15001
15001
15001
RESET
RESET
SW:S1J96902
SW:S1J96902
RESET
SW:S1J96902
90°
4.6) ERRORS:
90°
to notify the operator of procedural or operational errors.
max 90°
90°
max 90°
Message
max 90°
Y
ERROR
max.
max.
ERROR
NTC
max.
Y
BATTERY
FAULT
ERROR
BATTERY
ERROR
LED
BATTERY
ERROR
LED
ON
001
ON
LED
001
ON
LED
LED
001
OFF
01
001
OFF
LED
T
002
01
OFF
02
01
002
002
01
003
2
003
90°
003
2
004
2
004
2
BEEP
004
90°
BEEP
BEEP
90°
90°
min.
90°
BATTERY
Error screens are displayed for about 30 seconds before being reset, but will display repeat-
min.
edly in the event of permanent anomalies.
min.
min.
BATTERY
min.
BATTERY
BATTERY
Meaning
BATTERY
ERROR
ERROR
LOW
ERROR
BATTERY
TEMPERATURE
001
001
HIGH
001
002
002
REQUEST
002
MAINTENANCE
003
003
003
004
004
these appear during operation, combined with a beep and flashing LED Worklights,
004
Error description
The pressure release button (6) was
pressed before the control parameters
were reached (Force/Pressure).
min.
min.
Interruption of the signal from the NTC
min.
temperature probe of the battery.
BATTERY
BATTERY
001
LED
BATTERY
LED
Abnormal power consumption of the mo-
OFF
tor for more than 3 seconds.
OFF
LED
002
The tool stops.
OFF
LED
LED
ON
BEEP
ON
003
BEEP
LED
001
Output voltage of the pressure transmitter
ON
BEEP
is out of the pre-set range.
004
002
Failure to reach the set pressure within
30 seconds of continuous operation of
the machine.
003
Overcharging of the battery with protec-
tion tripping.
004
The tool stops.
LED
OFF
LED
LED
Replace or recharge the battery.
NOTE: when the battery voltage falls below a minimum safety
threshold, the tool will not start, although it is still possible to
end the work cycle in progress.
Remove the battery and wait until it cools down.
In order to cool quicker, it is possible to insert it into the supplied
battery charger supplied, thus making use of the specific "AIR
COOLED" function.
No. of cycles to recommended maintenance is reached. The tool
continues to work however, it is recommended that it is sent to
Cembre for a complete overhaul (Ref. to section 7).
NOTE: this message, will reappear when the tool has been idle
for 30 s.
Solution
Repeat the work cycle and wait for the
motor to stop automatically.
Replace the battery.
If the problem persists, please contact
Cembre.
Wait for the display to turn off (60 sec.)
or remove and re-insert the battery, then
re-start the tool.
If the error occurs frequently, contact
Cembre.
Repeat the work cycle; if the error occurs
frequently, contact Cembre.
Repeat the work cycle; if the error occurs
frequently, contact Cembre.
Wait for the display to turn off (60 sec.)
or remove and re-insert the battery, then
re-start the tool.
If the error occurs frequently, contact
Cembre.
Description
12
Publicidad
Tabla de contenido
