Activating Privacy Mode; Feeding Timer; Technical Data - Topcom BABYTALKER 1020 Manual De Usuario

Babytalker 1020
6.3

Activating privacy mode

The Babytalker 1020 operates on free frequencies (PMR - 446Mhz).
Any other PMR device in range, on the same channel can hear the transmitted babyphone signal.
This means also that the parents' unit can receive the signal from other PMR devices.
To avoid disturbance from other PMR devices, privacy mode must be activated on both parents' and baby unit.
Once the channel on the parents' unit and baby unit is the same,
- Press the set button
- Press the set button
• When privacy mode is activated,
6.4 Setting the transmission volume of the parents' unit
There are 8 volume levels.
- Press the button
8
- Press the button
6
6.5 Setting microphone sensitivity (VOX)
The baby unit operates on VOX mode. This means that the baby unit starts sending as soon as the microphone
detects sound. The sensitivity of the sound detection can be changed by the user.
When you increase the sensitivity, the baby unit picks up quieter sounds.
The VOX sensitivity can be adjusted by turning the VOX sensitivity switch
- Clockwise to the highest VOX sensitivity position
- Counter clockwise to the lowest VOX sensitivity position
6.6

Feeding timer

The feeding timer is a count down timer that can be used for generating an alarm sound to remind you on the next
feeding or medicine time.
To turn on the count down timer and set the timer.
- Press and hold the set button
displayed.
- Press the channel up
- Press the channel down
- Press the set button
Once the alarm is audible, press the set button
6.7 Night light on the baby unit
- Press the night light button
- Press the night light button
6.8 LED light on the parents' unit
- Press the LED light button
- Press the LED light button
7

Technical data

Channels
Sub-code
Frequency
Range
Transmission Power
Modulation Type
Channel spacing
Batteries
Power Adapter
once to activate privacy mode on the parent unit.
10
once to activate privacy mode on the baby unit.
17
to increase the volume.
to decrease the volume.
for 5 second. The feeding timer icon and feeding time interval is
10
button to select the hour.
3
button to select the minutes at 15' intervals (15, 30, 45)
4
to confirm.
10
to deactivate.
10
to activate the LED night light
20
again to deactivate the LED night light
20
to activate the LED light
5
again to deactivate the LED light
5
8
DCS
446.00625MHz - 446.09375 MHz
Up to 2 Km (Open field)
=< 500mW ERP
FM - F3E
12,5 kHz
Baby Unit: 3 x AAA 'LR03' Alkaline batteries
Parent Unit: Battery pack (3 x AAA Ni-MH batteries)
Baby Unit: Input: 230-240V~ 50Hz / Output: DC 7,5V/300mA
Parent Unit: Input: 230-240V~ 50Hz / Output: DC 7,5V/300mA
is displayed.
;
24
.
21
.
21
.
2
.
2
7