Operating The Device; Switching The Parents' Unit And Baby Unit On And Off; Setting The Channel - Topcom BABYTALKER 1020 Manual De Usuario

5.4.2 Connecting the baby unit to the mains
- Plug the small connector of the power adapter into the
power adapter jack
indicates, the jack is locked into position.
- Connect the power adapter (7,5V DC / 300mA) to a mains
socket (230-240V~ 50Hz).
• Only use the enclosed power adapter.
5.4.3 Inserting batteries into the parents' unit
WARNING
Injury and material damage can be caused by using
non-rechargeable batteries in the parents' unit!
• Only use the Ni-MH battery pack supplied with the
product.
• The parent unit can only be used with the
enclosed a Ni-MH battery pack. It cannot
be used with single cell Ni-MH batteries!
- Remove the belt clip.
- Push the battery cover
- Install the rechargeable battery pack following the polarity as
illustrated.
- Re-install the battery cover
5.4.4 Charging batteries in the parents' unit
- Connect the power adapter (7,5V DC / 300mA) to a
main socket (230-240V~ 50Hz).
• It takes about 10 hours to charge the
batteries.
6

Operating the device

6.1 Switching the parents' unit and baby unit on
and off
- Press the on/off button
- To switch on the baby unit, press the on/off button
- To switch off the parents' unit, press and hold the on/off button
- To switch off the baby unit, press and hold the on/off button
6.2

Setting the channel

To have communication between the baby unit and the parents' unit they need to be set both on the same channel.
- Press the channel up
unit.
- Press the channel up
the parent unit.
Once both units have the same channel, the parents' unit can receive the signal from the baby unit.
When on one or both units is displayed, the privacy mode is activated. Check chapter "Activating privacy mode"
on page 7.
6
on the side of the baby unit. A click
22
and slide it downwards.
13
and belt clip.
13
to switch on the parents' unit. The display
9
or channel down
3
or channel down
15
. The display
18
9
until the display goes out.
18
button on the parent to select the channel of the parent
4
button on the baby unit to select the same channel of
16
Babytalker 1020
Ni-MH
MUST BE RECYCLED OR DISPOSED OF PROPERLY
MADE IN CHINA
illuminates.
illuminates.
14
until the display goes out