Led Lighting; Using The Appliance; Operation And Use - WMF Lumero 3200001140 Instrucciones De Uso

WMF milk froth DISC
The WMF milk froth DISC (4) can be removed from the appliance for easy cleaning. To do this, gently
push down the WMF milk froth DISC (4) and slide it to one side.
To assemble the appliance, proceed as follows:
Simply slide the WMF milk froth DISC (4) sideways into the appliance, an internal magnet holds the
DISC fi rmly in place.

LED lighting

The LED lighting (7) on the appliance base (8) is used to indicate that the appliance is in operation and
when a programme is selected.

Using the appliance

Before using for the fi rst time, ensure the appliance is thoroughly cleaned, as detailed in the "cleaning
and care" section.
Any surplus cable can be wound into the bottom of the base unit (8). Connect the mains plug to an
earthed socket.
12

Operation and use

1. Add the required amount of milk to the jug (5) and close it with the lid (1).
2. Place the jug (5) on the base (8).
Warning:
Always place the lid (1) securely on the jug before switching it on.
Never remove the lid (1) while the appliance is running.
Note:
Preparation can be stopped at any time by lifting the jug (5) off the base (8).
Allow the appliance to cool down before reuse.
The quality and volume of the milk froth depends on the milk used (e.g. the fat and protein content,
temperature, etc.).
Hot milk froth
Select this programme for hot, creamy, fi ne milk froth. This is particularly suitable for cappuccino or
latte.
▪ Add 100 to150 ml of cooled milk to the jug (5) (exception: you can fi ll up to
250 ml of hot milk).
The fi ll markings are located inside the jug (5), alternatively you can also use
the mixing arm (3) for guidance:
100 ml MIN, so that the WMF milk froth DISC (4) is covered.
150 ml MAX , alternatively up to the lower marking on the mixing arm.
Do not add more than that, otherwise the milk froth will overfl ow and soil
the appliance.
▪ Place the lid (1) on the jug (5) and apply slight pressure to ensure a good seal.
Press the Start/Stop button (6) repeatedly until the corresponding symbol
lights up. Approx. 3 seconds later, the control light on the Start/Stop button
(6) lights up and preparation begins automatically.
▪ After the programme ends, the appliance switches off automatically and
the indicator light turns off. Remove the lid (1) and skim off the milk froth
separately, or pour it out with the remaining milk.
Creamy, soft milk froth
Select this programme to get warm, creamy, fi ne-pored milk froth. This is particularly
suitable for cappuccino or latte art.
Strong milk froth
Select this programme to get warm, consistency milk froth. This is particularly suitable
for cappuccino or latte macchiatto.
Cold milk froth
Select this programme for cold, creamy, milk froth. This is particularly suitable for
frappé drinks, cocktails, iced coffee and desserts.
Hot milk
Select this programme to heat milk and slightly froth it. Hot milk is particularly suitable
for milky coffee, hot chocolate and cocoa.
13