Adjusting Blade Parallel To The Miter Gauge Slots - skilsaw SPT99 Instrucciones De Funcionamiento

ADJUSTING BLADE PARALLEL TO
THE MITER GAUGE SLOTS
The blade was adjusted parallel to the miter
gauge slots at the factory. In order to insure
accurate cuts and help prevent kickback, this
adjustment should be rechecked. If adjustment
is necessary, follow the steps below.
To prevent personal injury,
always dis con nect the plug
from the power source before mak ing any
adjustments.
1. Turn elevation wheel and raise blade as high
as it will go.
2. Select a point on the body of the saw blade that
is set to the left when viewing the blade from
the front of saw, and mark with a pencil (Fig.
26).
3. Place the base of a combination square
against the edge of the miter gauge slot, and
extend the sliding rule of the square so it just
touches the marked point on the body of the
saw blade at the rear of the table.
4. Rotate the blade and check the same marked
point of the saw blade at the front of the table
(Fig. 26).
5. If the front and back measurements, shown in
Figure 26, are not identical, loosen the four
alignment bolts, located on the underside of
the table at the front and rear of the saw with
the hex wrench supplied with your saw, (Fig.
27 & 28). Carefully move the saw blade until
the blade is parallel to the miter gauge slot,
and securely tighten all four bolts.
Adjustments
FIG. 26
FIG. 27
FIG. 28
-29-
Mark
Front of Table
Alignment Bolts
Alignment Bolts
Rear of Table