Storage, Transporting, And Mounting; Smart Guard System Storage; Rip Fence Storage - skilsaw SPT99 Instrucciones De Funcionamiento

Tabla de contenido

Idiomas disponibles

SMART GUARD SYSTEM STORAGE

When not in use, the Main Barrier Guard and An-

ti-Kickback Device can be stored under the table.

Use of all the components of the Smart Guard

System, including Main Barrier Guard, Anti-Kick-

back Device, and riving knife is highly recom-

mended to provide protection against accidents

and injury.

1. Lock the Main Barrier Guard assembly into place

in the same manner as you would attach it to the

riving knife (Fig. 16).

2. Attach the Anti-Kickback Device to the hanging

bracket in the same manner that it attaches to the

riving knife (Fig. 17).

DUST CHUTE ELBOW STORAGE

When not in use, the dust chute elbow can be

stored under the right side of the table (Fig. 17).

RIP FENCE STORAGE

When not in use, the rip fence can be stored

under the left end of the table on the rails.

1. Remove the fence from its in-use position on the

rails.

2. Unlock the rails and extend the rails approxi-

mately 2" to the left of the table. (Fig. 18).

3. Hang the fence upside down under the rails,

using the left side bolt locations as position indi-

cators. Ensure that the flip-over fence, in its

stored position, is facing away from the table saw

frame.

4. Latch the front and rear lock levers

5. Gently slide the rails back toward the center until

the fence is close to the table saw frame, and

then engage the rail locking lever.