Unpacking And Checking Contents; Table Of Loose Parts - skilsaw SPT99 Instrucciones De Funcionamiento

To avoid injury from unex-
pected starting or electrical
shock during unpacking and setting up, do
not plug the power cord into a source of
power. This cord must remain unplugged when-
ever you are assembling or making adjustments
to the table saw with stand.
Model SPT99 Table Saw and stand is shipped
complete in one carton. To make the assembly of
the stand easier, place the table saw with the table
surface towards the ground.
Separate all parts from the packing materials
and check each one with the illus tration and
the list of Loose Parts to make certain that all
items are accounted for before discarding any
packing material (Fig. 3).
If any parts are missing, do
not attempt to assemble the
table saw, plug in the power cord or turn the
switch on until the missing parts are obtained
and are installed correctly.

TABLE OF LOOSE PARTS

ITEM DESCRIPTION
1 Table Saw
2 Dust Chute Elbow
3 Table Insert
4 Barrier Guard Assembly
5 Anti-Kickback Device
6 Miter Gauge
7 Push Stick
8 Handle bar for Stand
9 H Shaped Bar for Stand
10 Wheels
11 Manual
Bag of Fasteners
12
(check contents on page 16)
REMOVE CABLE TIE AND
STYROFOAM BLOCK
(Used for shipping purpose only)
With the table surface on the ground, locate the
cable tie that anchors the motor/blade assembly
to the base. Using scissors or wire cutters, cut
and remove the cable tie (Fig 4).

Unpacking And Checking Contents

Release the blade tilt lock handle, tilt the blade to
45 degrees, then remove styrofoam block located
between the motor housing and the table.
QTY.
1
1
1
1
1
1
1
1
1
1
1
1
-15-
FIG. 3
FIG. 4
Remove
Styrofoam
Block
Remove
Cable Tie